The stone engraving machine is a precision numerical control equipment. Today, Xiaobian tells you that the necessary daily maintenance and maintenance is essential to the service life and accuracy of the machine. Please perform the maintenance and maintenance as described below.
1. The continuous running time is less than 10 hours per day to ensure the cleaning of the cooling water and the normal operation of the pump. The water spindle motor must not be dehydrated, and the cooling water should be replaced regularly to prevent the water temperature from being too high. In winter, if the working environment temperature is too low, the water in the water tank can be replaced with antifreeze.
Second, each time the machine is used, it is necessary to pay attention to cleaning. It is necessary to clean the dust on the platform and the transmission system, and regularly and weekly (weekly) lubricate the transmission system (X, Y, Z three axes). (Note: X, Y, Z three-axis polished rods are maintained with oil; high-speed butter is added to the screw; in winter, if the working environment temperature is too low, the screw, polished rod (square rail or circular guide) should be cleaned with gasoline first. Then add the oil, otherwise it will cause the resistance of the machine transmission part to be too large and cause the machine to be misaligned.)
Third, the maintenance inspection of the electrical appliance is, must cut off the power supply, until the monitor has no display and the main circuit power indicator is off, before maintenance
As for the protection of other parts of the stone engraving machine, such as pumps. Cutting the main shaft, the two are each other, always replace the circulating water, adhere to the water and water temperature to block the water pump outlet or the water-cooled cutting spindle works at high temperatures to form component damage.
Through the understanding of the above-mentioned stone engraving machine, I hope to help you.
