1. Acrylic cutting processing, it is recommended to use single-blade spiral milling cutter, which is characterized by smokeless and odorless, fast, high efficiency, non-sticky, and truly environmentally friendly. Its special manufacturing process guarantees that processing acrylic does not explode. , very fine knife pattern (even without knife), the surface is smooth and flat. The surface needs to be frosted. It is recommended to use a double-edged three-blade spiral milling cutter.
2. MDF cutting process (for advertising mold opening), it is recommended to use double-blade large chip spiral milling cutter, which has two high-capacity chip flutes and double-edged design, which has good chip removal function and reaches Very good tool balance, no blackening, no capping, long service life, etc. when processing high density boards.
3. For aluminum sheet cutting, it is recommended to use a single-blade special aluminum milling cutter. It does not stick to the knife during processing, and it has high speed and high efficiency.
4. The upper and lower burr-free cutting process, it is recommended to use a single-edged, double-edged upper and lower cutting cutter.
5. For metal engraving machine processing, it is recommended to use a single-blade, double-blade straight groove flat-bottomed sharp knife.
6.3D engraving knives, high concentricity, sharp edge, can do precision 3D engraving.
7. High-density board, solid-wood milling cutter is recommended.
8. Multi-layer board, splint processing, it is recommended to use double-blade straight slot milling cutter.
9. Precision small relief processing, it is recommended to use a round bottom knife.
10. Cork, MDF, native wood, PVC, acrylic large deep relief processing, it is recommended to use single-blade spiral ball end mill.
11. The effect of the lower cutter is that there is no burr on the upper surface of the processed product, and it will not be rocked when processed.
12. Metal mold milling cutter, it is recommended to use tungsten steel milling cutter, the surface is plated with purple black and hard titanium.
13. The use of diamond engraving knives is recommended for acrylic mirror engraving.
14. Multi-strip milling cutters are recommended for roughing particleboards.
Second, each time the engraving machine is used, it is necessary to pay attention to cleaning. It is necessary to clean the dust on the platform and the transmission system, and regularly and weekly (weekly) lubricate the transmission system (X, Y, Z three axes). (Note: X, Y, Z three-axis polished rods are maintained with oil; high-speed butter is added to the screw; in winter, if the working environment temperature is too low, the screw, polished rod (square rail or circular guide) should be cleaned with gasoline first. Then add the oil, otherwise it will cause the resistance of the machine transmission part to be too large and cause the machine to be misaligned.)
Third, the maintenance inspection of the engraving machine is, must cut off the power, until the monitor has no display and the main circuit power indicator is off, before proceeding.
